How do I install the Freefly Receiver that came with my Mimic Beta?

Mimic Beta Receiver Installation : M10

1. Remove the Spektrum Receiver and 3-pin cable (if applicable).
2. Plug the shorter 5-pin cable that came with the MIMIC into Mōvi Data port on the Gimbal Controller.
3. Plug the other end of the 5-pin cable into the Mōvi Data port on the receiver.
4. Remove the adhesive backing from the receiver.
5. Attach the Receiver to the Gimbal Controller as shown.

Mimic Beta Receiver Installation: M5/M15

1. Remove the Strain Relief cover from under the Gimbal Controller (1.5mm hex screws).
2. Remove the Spektrum Receiver and 3-pin cable (if applicable).
3. Plug longer 5-pin cable that came with the MIMIC into Mōvi Data port on the Gimbal controller.
4. Route the 5-pin cable with the other wires through the strain relief track.
5. Replace the strain relief cover.
6. Plug the other end of the 5-pin cable into the Mōvi Data port on the Receiver.
7. Remove adhesive backing from the Receiver.
8. Attach the Receiver to the Gimbal Controller shown.